Ask About

Why is my dish remote not working on TV2?

By Laura S. Harris
Feb 26, 2021

On TV2 remote, hit 'Sat' button & then hit 'Record'. If still not working, hold the power button on the front of the receiver for 10 seconds. If it still doesn't work after reset, call Dish for replacement remote.

How do I get my Dish remote to work on my TV?

Program Remote to TV or Other Device. Press the HOME button twice, or the MENU button once, depending on your remote. Select Settings. Select Remote Control. Arrow to and select the device code you want to learn. Select the appropriate Pairing Wizard for the device. Follow the on-screen prompts.

How do I reset my Dish remote to my TV2?

From tv 1 press the menu button twice and it'll take you to the system info screen. Make sure the tv2 antenna is plugged in the back of the receiver then take the tv2 remote press and hold the satellite button at the top left side of the remote until it stays lit then press a number, any number.

How do I program my TV2 remote to my dish receiver?

You can program the remote control to operate any other DISH Network receiver except where UHF is used, such as TV2 on DISH Network receivers. Turn on the second receiver and open System Info screen. Write down the TV2 address shown. Press and hold AUX until all Mode buttons light up, then release the button.

How do you program Dish remote to TV 2?

Program Remote. On the front panel of your receiver, press the SYSTEM INFO button. (Buttons are behind the door on the right side of the front of the receiver). On the front of your remote, press the SAT button. Press the RECORD button. Select Done.

How do I change my dish remote from 2 to 1?

After holding down the white 'sat' button, you press any number from 1-15 then hit the # key. The white sat button will blink 3 times if you put in a valid number. Then you press the record button and the receiver will will change its code to the one you selected for the remote.30 May 2009

How do I reset my Dish remote control?

Reset and Program Dish Remotes If you have confirmed you are using the correct remote and problems persists, press the Sat button on the remote, followed by the Sys info/System info button on the front face of the receiver. At this point, press the Sat button on the remote again.14 Jun 2019

How do I switch my dish remote from TV1 to TV2?

Select the TV1 UHF Pro Setup screen and select Enable. System Info screen. Use the ARROW buttons to highlight the Rem Addr box. Note: If you do not move the highlight, the remote changes the receiver's Rem Addr box and causes the remote to control the TV2 side of the receiver.

Already on YouTube

References

Terms and Conditions   •   Privacy Policy   •   Cookies Policy

“Ask About” Publishing © 2019-2025